鐵絲訂書設備 廠家

鐵絲訂書設備電氣使用說明 Electric

可能出現的異常、故障及排除方法 Trouble shooting

8.1 鐵絲訂書設備沖孔系統故障排除 Punching system trouble shooting

   8.1.1   故障現象：機器不動 Symptom: The machine does not move
           產生原因：電源沒有接通或者保護開關觸發異常。

Cause: The power supply is not turned on or the protection switch is triggered
  排除方法：查看電源開關是否已經接通，保護開關有無異常， 配電箱內空氣開關是否斷開。

Remedy: Check whether the power switch is switched on, whether the protection switch is abnormal or not, and the air switch in the distribution box is disconnected
8.1.2異?，F象：毛邊大

Abnormal phenomenon: big hair
  產生原因：紙張太厚，沖針嚴重磨損

Cause: The paper is too thick and the punch is severely worn
  排除方法：正常運行紙張厚度建議在1-6mm之內；如果是沖針磨損嚴重請更換。Remedy: normal operation of the paper thickness is recommended within 1-6mm; if the pins wear, please replace.

8.2 鐵絲訂書設備機械手送料系統的故障排除 The feed belt system trouble shooting

   8.2.1 故障現象：機器不動Symptom: The machine does not move
         產生原因：電源沒有接通或者光電開關觸發異常。Cause: The power supply is not turned on or the photoelectric switch triggers an abnormality
         排除方法：查看電源開關是否已經接通，光電開關有無異常。Remedy: Check whether the power switch is turned on, the photoelectric switch is abnormal.

   8.2.2  異?，F象：機械手抓取和送料位置不對             Abnormal phenomenon: the robot grab and feeding position is wrong

   產生原因：皮帶拉長松弛或者是皮帶固定塊1不牢靠。        Cause: The belt is stretched or the belt is fixed

   排除方法：將皮帶張緊到合適的松緊度，調整好機械手的位置鎖緊皮帶固定塊。Remedy: Tighten the belt to the appropriate tightness, adjust the position of the robot to lock the belt fixed block.

鐵絲訂書設備北京市  廣東省  山東省  江蘇省  河南省  上海市  河北省  浙江省  香港特別行政區  陜西省  湖南省  重慶市  福建省  天津市  云南省  四川省  廣西壯族自治區  安徽省  海南省  江西省  湖北省  山西省  遼寧省  臺灣省  黑龍江  內蒙古自治區  澳門特別行政區  貴州省  甘肅省  青海省  新疆維吾爾自治區  西藏區  吉林省  寧夏回族自治區