天津臺歷全自動YO單/雙線圈裝訂機廠家電話價格報價

5.2.4調整好臺歷 掛歷 筆記本全自動YO單/雙線圈裝訂機插針以后,把線材一端折彎成鉤狀, 延順時針方向向右環繞芯棒,穿過每根插針,見圖二.穿線后,按”手動繞線”按鈕,使線材環繞芯棒轉動,拉出首段線圈剪掉(因開始手動穿線時的原因,形狀不良).

After the pins installed, pressed the wire with hook shape, turn clock wise with the wire goes through each pines as photo 2. After the wiring done press “Manual Wiring Button” which turns around the mandrill running. Pull out the first sect and cut it out. (Because of wire shape no good when the first manual wiring).

5.3 臺歷 掛歷 筆記本全自動YO單/雙線圈裝訂機調試齒距 Teeth pitch adjustment
齒距是通過以下三個零件固定的，1插針板、2插針、3導線塊

There are three parts supporting with the wire. 1. The pins. 2. The pin stands and 3. The teeth guide.
5.3.1導線塊是各種齒距通用一個規格，只須通過調整導線塊旁邊的“齒距調節螺絲”將其左右移動位置。Wire running teeth guide is a kind of common specification. Just loosen the screws can move it to left or right position.
5.3.2穿好線之后先用“手動繞線”生產一段線圈,檢驗齒距是否符合要求(可以在機器上的導向齒距條上檢驗),如齒距偏大,則把“齒距調節螺絲”順時針旋轉,反之亦反。Upon the wire setup done “manual wiring” trial suitable length of coil. In case double check each coil is qualified passed. (Can inspect onto the machine on the teeth pitch guide).If the teeth pitch bigger adjust screws turn clock wise. If teeth pitch smaller, turn against the direction.

5.4臺歷 掛歷 筆記本全自動YO單/雙線圈裝訂機調試切刀 Cutter adjustment

5.4.1 先調試左切刀,刀口的開口中間位置對準需切斷的線圈位置,刀口進入線圈約1/3,見下圖.用同樣的方法調試右切刀 。Adjust the left cutter; the centre of the cutter must face the wire cutting position. The cutter should be entered the coil 1/3 of depth. See photo 3. Use the same way for the right cutter for inspection.