臺達電機ECMA-E11310RS

臺達電機ECMA-E11310RS
聯系人：魏工    電話：15882174684 
            座機：028-84472033  QQ：2030149354
產品資料：

Extraction Procedure

(1) Disconnecting Components

• Disconnect all components on the cap side from the cover.

(2) Extracting Pin Block

• Insert the claws of the Tool into the four holes of the cover.

• Make sure that the pin block is outside the Tool.

• Press the Tool so that the guides of the Tool are in close contact.

Then pull the pin block straight.

Precaution for Safe Use

• The pin block must not be extracted from the same Connector

more than 3 times, otherwise the proper degree of protection of the

pin block or Connector will not be maintained.

Crimp Tool

XY2F-0002

Locator

XY2F-0003

5 4 3 2 1 8 7 6

RAISE TO ROTATE

SEL.

NO. PUSH POSTITONER AND ROTATE 90° T O NI S AT LL

ROTATE 90° TO INSTALL

Tool in open position

Tool in closed

position

XY2F-0002

Crimp Tool

XY2F-0003

Locator

Selector dial

(Set to 8.) Locator guide

Model

XY2F-0002

XY2F-0003

Pin-block Extraction Tool

XY2F-0001

Use this tool to extract a Pin Block from the covers in order to make

wiring changes or corrections after the cover has been mounted to the

pin block for Connector Assemblies (XS@C/XS@G, soldering/

crimping)

Assembly Procedure for XS5C/XS5G (IDC models) Connector Assemblies

(1) Preparations (Make sure they are all at hand.)

(2) Dressing the cable end

•Peel covering of a cable.

(3) Choose the waterproof bushing