Amplitude calibration from 10MHz – 20GHz
Open source Labveiw GUI software control via USB
Run hardware functions with or without a PC
32-bit ARM processor on board
Two channel frequency, phase and amplitude control
Quadrature (or other phase) LO signal generation
1Hz frequency resolution
01 degree phase control on each channel
100uS RF lock time standard
Up to +20dBm output power
01dB amplitude resolution
Over 50dB of power control
Absolute power display on Software GUI
10MHz – 100MHz external reference input
Selectable 10 or 27 MHz internal reference output
5ppm internal reference accuracy
Internal and external FM, AM, Pulse Modulation
Pulsed FMCW Chirp
External sweep, step and modulation trigger
500 point frequency and amplitude hop table
Dual channel frequency and amplitude lock
Channel enable / disable saves energy
5 Ultra low noise linear regulators on board
0 X 2.15 inches not including RF connectors
USB or UART control via USB-C connector
Operation from 20GHz to 24GHz is uncalibrated
