邢臺環鏈電動葫蘆

       邢臺環鏈電動葫蘆用于腳手架整體提升時，應由專人安裝，操作，懸掛結束后，空載試運行，檢查各連接件、起重鏈、吊鉤等有無異常，確認完好后方可使用，掛架前應調整起重鏈條的長度，使掛架后每臺起重鏈條的張緊度一致，提升時，應由專人觀察每臺產品，查看腳手架是否與墻體相碰，提升機是否有異常聲音或卡鏈，發現異常應立即停機檢查，排除故障后方可繼續使用。

Shijiazhuang ring chain electric hoist for the overall lifting of the scaffolding should be installed by hand, the operation, after the end of suspension,
Test run, check the connection piece, lifting chain, hook without exception, confirm intact before use, hanging
Before the lifting frame should be adjusted to the length of the chain, so that after each rack lifting chain tension, promotion, should be
By observation of each product, check whether the scaffolding colliding with a wall, elevator if there is abnormal sound card or chain,
Found abnormalities should be immediately shut down inspection, troubleshooting before continuing to use.

         我們建議廣大的操作者，為了減少對電動葫蘆造成不必要的損壞，請您在每次使用完畢后保持產品清潔，妥善保管，防止受潮、腐蝕。每年應由熟悉產品結構人員，用煤油清洗機件，在齒輪與軸承部分加黃油潤滑，減速器內重新更換機械油產品的制動部件在出廠時以調整合理，不允許隨意改變。檢修完成后，應進行空載和負載試驗，確認正常后方可使用。

由于我們的產品在不斷的升級改造，為了達到您最滿意的效果，請?jiān)谫徺I前通知我們的客服人員或者撥打聯系方式：13933002678  0311-89619123